Controller - Nunchuck

1. The Nunchuck Controller

The ergonomic Nunchuck controller uses RF to connect to the Spine’s motor and needs 2 normal AA batteries. It has four buttons:

White Speed/Break stick: Top (thumb)
- Push forward to Accelerate, backwards to brake
Blue Cruise Control Button: Backside
- Push and hold to maintain the same speed, regardless of incline changes
Red Direction Button: Backside
- Push once to change Direction - Reverse/forward
Small white connector button: Front right
- Push once to connect to Spine Bluetooth receiver
- Blue light in front left side of controller indicates connection:
  - Steady Blue light = Connected
  - Blinking Blue light = Searching connection
  - No light = Off

NOTE: Can’t seem to turn the Nunchuck off? Just take out the batteries and put them back.

2. Driving instructions

Driving a Faraday Spine is thrilling and great fun, but take care. This is not a toy, it is a means of transportation. Thus, show careful alertness and abide by local traffic regulations.

IMPORTANT POINTS:

ALWAYS make sure your controller is working properly
- Smartphone prepared as described in section 3.1.2
- Nunchuck battery level okay
Connect the wi-fi to the board, before starting the app
Wear safety gear when driving (at least helmet)
Beware of water – electronics are nano covered, but not 100% waterproof
Inform people not to step on the back motor unit
Max allowed weight 120kg
Stop riding instantly if batteries seem weak (performance drops)
ALWAYS unplug cables when the vehicle is not in use