Introduction

1. Read This Before You Start Assembling

Make sure to always pre-drill the holes that you are going to screw screws in. The drill size should be close to the diameter of the screw you are about to use.
Make sure that before getting to the Stage 2 Step 4: Complete the assembly of the Spine Box , you are aware that your motor controller is configured and will not require to be connected to a computer via cable.
All support material from the 3D Printed parts needs to be removed before starting assembly.
3D Printed parts can be painted or clear coated to keep their visual looks better
Imperfect prints should be replaced as they may endanger your safety
Sometimes 3D Printed parts need to be fine touched with a knife in juncture place where two or more pieces come together.
Make sure you have downloaded and printed the latest parts based on the 3D files from http://faradaymotion.com

The battery is fully charged
All the screws, bolts and nuts are tightened
Your phone is at least at a 50% charge level
Wheels are turning with no restriction and do not wiggle
Wear a helmet before you get on the board
Check all cables for punctures to dismiss possibility of shortage
Motor is turning with ease and not making any sounds that could indicate that there is something inside itself

Allan key with a diameter of 2.5mm
2 Torx Screw Drivers
- TX 10
- TX 20
Drill for pre-drilling the plastic
- The screws with an outer diameter of 3 mm require a drilled whole of 2 mm
- The screws with an outer diameter of 4 mm require a drilled whole of 3 mm
Wrench with a size of 13
Knife for cutting the excess plastic from the 3D Printed parts

If you plan to 3D Print your own Faraday Motion Spine we highly recommend that you take a look at our 3D Printing Guide